Unboxing the kit
The manual.
Applied cement to remove the seamline in the middle.
I will sand it after the cement dries.
Look what I found again in my storeroom.
My freakin 20 year-old styrofoam float which I used for my swimming lessons in primary school! >_<"
I have given an old thing a new lease of life again.
I am using it to pierce my satay sticks in. ^^
Preparations for priming. I am going to use Tamiya fine grey surface primer.
Double GN blades
V-fins. I tried to make the tip slightly sharper by using a file.
Personally, I dun like it too sharp.
Twin GN drives.
So, that's what I have managed to complete for today. Any advise on the priming process? Any important things to take note of? Please comment below. Thanks!
Peace Out,
Gunpla Warrior
just wondering why you gona use grey for priming? what color sheme you gona do?
ReplyDeleteHi there,
ReplyDeleteI use the grey primer bcos I see most modeler uses it.
I also have white primer. I am thinking of spraying another layer of white primer on the white-coloured parts.
I plan to follow the original colour scheme.